1. Grasp the plug and remove it from the receptacle or other outlet device. Do not unplug the string by pulling on the cord.
   
2. Pinch the grooves on the sides of the socket. Gently pull the lamp base upwards.
   
3. Align the grooves in the base of the replacement lamp with the grooves in the socket.
   
4. Gently push the lamp into the socket until you hear a SNAP. That means the lamp base is locked in place.
   
5. Replace the lamp only with a matching lamp from the set.
   
6. In case the lamp base of new replacement lamp does not fit lamp holder:

• Remove the lamp from its base by straightening the wires and pulling the lamp out of the base.
• Insert the new lamp into the base by fitting wires thought the two holes in the bottom of the base and then bending the wires up onto the sides of the base.
• Insert the completed lamp/base unit into lamp holder.

1. Grasp the plug and remove it from the receptacle or other outlet device. Do not unplug the string by pulling on the cord.
2. Open the fuse cover. Slide open the panel located on the top of the attachment plug towards the blades to expose the two fuses.
3. Remove the fuse carefully by turning the attachment plug over.
4. To avoid the risk of fire, replace the fuse only with the correct amperage replacement fuse (check packaging).
5. Close the fuse cover by sliding the panel on top of the attachment plug.

Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.