For Expert Help Call 1-800-624-4488

F72T12 - F96T12 Fluorescent Ballasts | HO Ballasts

Do you need a new ballast for a T12 fluorescent fixture using high output lamps? Consider installing these T12 ballast replacements.

 
Advance Centium ICN-2S110-SC - (2) Lamp - F96T12/HO - 120/277 Volt - Rapid Start - 0.89 Ballast Factor


BA-ICN2S110SC35

Advance Centium ICN-2S110-SC

Advance Centium ICN-2S110-SC - (2) Lamp - F96T12/HO - 120/277 Volt - Rapid Start - 0.89 Ballast Factor

  • Brand: Advance
  • MPN (Part No.): ICN-2S110-SC-35I
  • Family: Centium
  • Safety Rating: UL Indoor
  • Voltage: 120
  • Ballast Factor: 0.89
  • Start Temp. (Min): -20 Deg. F
  • Power Factor: 98%

  • Start Method: Rapid Start
  • THD: 10%
  • CSA Listed: Yes
  • Length: 9.5 in.
  • Height: 1.18 in.
  • Width: 1.7 in.
  • Weight: 1.65 lb.
  • Warranty: 5 Years
$31.92 ea.

VOLUME DISCOUNTS AVAILABLE
CALL: 1-800-624-4488

BA-ICN2S110SC35

Howard EP2/110RS-MV - (2) Lamp - F96T12/HO - 120/277 Volt - Rapid Start - 0.88 Ballast Factor


BH-EP2110RSMVSC

Howard EP2/110RS-MV

Howard EP2/110RS-MV - (2) Lamp - F96T12/HO - 120/277 Volt - Rapid Start - 0.88 Ballast Factor

  • Brand: Howard
  • MPN (Part No.): EP2/110RS-MV
  • Safety Rating: UL Indoor/Outdoor
  • Voltage: 120
  • Ballast Factor: 0.88
  • Start Temp. (Min): -20 Deg. F
  • Power Factor: 98%
  • Start Method: Rapid Start

  • THD: 10%
  • CSA Listed: No
  • Length: 11.8 in.
  • Height: 1.6 in.
  • Width: 2.15 in.
  • Weight: 2.75 lb.
  • Warranty: 5 Years
$34.31 ea.

VOLUME DISCOUNTS AVAILABLE
CALL: 1-800-624-4488

BH-EP2110RSMVSC

Our T12 HO ballasts operate two 72 or 96-inch fluorescent high output lamps using the rapid start method. When a low voltage current is applied, rapid start ballasts preheat the filaments before sending a stronger voltage to start the lamp. This start up method puts less stress on the filaments, extending the life of the lamp. It is important to note that these T12 ballasts do not function as efficiently in temperatures lower than 50 degrees Fahrenheit.

Ideal for general overhead lighting, T12 HO ballasts are commonly used in stores, offices, board rooms, and other similar locations. Indoor rated ballasts should be used only in dry locations where the ballast will not come in contact with any moisture or water. Outdoor rated T12 replacement ballasts should be protected from direct contact with water and other weather conditions.

Not sure which T12 ballast is the right match for your application? Our knowledgeable staff of lighting experts is here to help. Call 1-800-624-4488 today!